DS-CONNECT board v3.2

The board for connecting ds18b20 sensors is up to 100 pieces when connecting additional splitters ( without splitters - up to 10 pieces).
Specifications
A 4.7 kOhm pull-up resistor is installed on the board
The board has an 8p8c connector for connecting to the nameplate (power is taken from it) and 10 4p4c for connecting ds18b20 sensors
It is also possible to connect one board to another using a 4p4c wire to increase the number of sensors on the line (to do this, remove the 4.7 kOhm resistor)
An LDO step-down voltage from 12 to 5 V is installed on the board (so that voltage drawdown in long wires does not affect the stability of operation)
Pinout of the ds18b20 sensor connector:
1-pin 2-gnd 3- Pass 4- Vin